1、沙盤模型做好后有一個運送轉移的過程，在這個過程中**有專人拆裝，而且要避免陽光直射和在陽光下暴曬。
1, do a good job in the sand table model after a transit transfer process, in this process must be hand dismantling, and to avoid direct sunlight and in the sun exposure.
2、濟南模型公司室溫要控制在35左右不可偏差太大，室內濕度要控制在30%~80%，并且室內要保持潔凈、通風良好。
2, room temperature should be controlled at 35 or so is not too large, indoor humidity should be controlled in 30%~80%, and the room to keep clean, well ventilated.
3、如果沙盤模型沒有玻璃罩，**經常清掃。
3, if not the glass sand table model, must be cleaned regularly.
4、沙盤模型的燈光不應長時間開放。
4, sand table model lights should not open for a long time.
5、有的沙盤模型會有真水噴泉，這種模型**經常檢查噴泉池內是否有水。更多咨詢請關注濟南沙盤模型公司官網：www.lltysb.cn